Wide, 18C Pantry Shelving
Wide panty shelving. 7 shelves ~6’7” long, plus short. Paint and staining from centuries of use. Widths on boards. Cost: (1730-2) SOLD
Wide panty shelving. 7 shelves ~6’7” long, plus short. Paint and staining from centuries of use. Widths on boards. Cost: (1730-2) SOLD
This is the first offering from a treasure trove of early 18C original wall board from a single, 1730 cape in MA. Four wide, hand planed, unpainted, thick (proud 1”), matching boards. Widths of 16”-17” and all 7’10”. Cost: (1730-1) SOLD
Fantastic early entry stone from Epsom, NH. ~7’4” long x 23” wide x 7” tall (edges) with ‘belly’ (not flat on bottom). Perfect for a large door entry stone or could be used lengthwise as part of a walkway or in concert with ‘granite walkway stones’. Great tooling and lichen growth on top and 3 [...]
Stair tread stock. #22 pieces of a mix of pines from a barn in NH. They measure 2” x 11.5” x 6’+/-. They are rough sawn and could be dressed for ‘open’ treads of a thickness very close to 2”. The 2" tread stock has the tight paint on one side. Cost: (batch #91) #22 [...]
450sf+ of super wide, hand-planed and foot worn, antique Red Pine (aka Northern Hard Pine). Native to New England, it is a very heavy and dense wood and tight grain. It is often mixed with White Pine in old houses because they can look very similar. This is an assembled batch from different houses. It [...]
700sf of hand planed, butt edged, antique Hemlock flooring. This material is very nice quality, and the original surface is smooth enough for most people to use ‘as is’ without sanding or even a finish if desired. The Hemlock is much harder and denser than White Pine. The hand-planed surface is visible with boards lightly [...]
350sf of wide, high quality, sand-grade white pine. This material was too wide and too nice to put into the lower prices sand-grade batch…but it could be added to it if needed. Most of the material is unpainted and quite wide. It will make a nice sanded antique floor. Widths of ~10” -18”+/- and lengths [...]
This is the largest 18C spring latch I have seen. It measures ~12” from left to right (13” including tip of bar) x 6” at right side of plate. The end of the bar is 1.5” wide. It fits a 1" thick door, but with a bit of welding, the shaft can be made to [...]
590sf of long, wide and thick, hand planed and foot worn 18C Red Pine flooring from South Windsor, CT and a similar thickness batch from MA. The flooring is a proud 1”+/- and very heavy and dense. The flooring should be sanded and buffed to bring out the great Red Pine colors. Widths of 7” [...]
700sf of fabulous white pine attic flooring from NH. Great foot worn, straight sawn surface with some boards worn more than others, which typical attic floors of this age. Most of these boards were ‘pegged’ with rectangular 3.5” wooden pegs, hand carved. First picture shows the sub-flooring with two pegs sticking out where the top [...]